Xuchang Tiantai Industrial Co., Ltd.

Xuchang Tiantai Industrial Co., Ltd.

Xuchang Tiantai Industrial Co., Ltd.
Xuchang Tiantai Industrial Co., Ltd.

Xuchang Tiantai Industrial Co., Ltd.

Xuchang Tiantai Industrial Co., Ltd.


Check category


ADDRESS:Middle Section of

Yinghao Road, Shangji

Industrial Cluster District,






How to curing wig

How to curing wig

2013-04-26 16:33

  1, try not to close to the high temperature, because the material relationship wig is not high temperature resistant

  2, wig can't dyeing, if need to trim the can please professional hair stylist trimming

  3, wig is usually 1 to 2 months or so wash one according to the frequency of wear

  4, cold water or warm water cleaning, washing, and use it every time you general shampoo with respect to OK can cooperate with general hair conditioner

  5, wash clean wig try not to use the air blower and so on high temperature wind blow dry,  the application of dry towel blot wig gently on the excess water put to ventilated place to avoid direct sunlight damage wig

  6, after washing don't immediately carding wig should wait for wig dry after the comb

  7, use special wig comb (steel comb or iron comb is better) can't use plastic comb!

  8, curl basically do not use comb, roll place every time bring by hand after finishing it

  9, if wig with long knot bad comb,  you do not force pulling, should spray wig dedicated non oily maintenance liquid, then slowly be geographical open

  10, pay attention to don't spray on the wig? Gel water, wax, the use of real hair conditioner that will make a wig become sticky greasy

  11, use wig dedicated non oily maintenance fluid use method is very simple: take lightly spray before a few times in the wig can) can make the wig become smooth and bright and can prevent electrostatic, let wig keep moist state like just to buy back!

  12, wig can tie up, just can't run too high or below their true hair will run out

  13, a relatively long wig comb should wig points long paragraphs, from down to up to comb, be sure to light, want to have patience

  14, in order to wear in the process to have a small amount to hair belongs to the normal phenomenon

  15, usually don't wear it in the original packaging, take a left back to its original shape when the do not put in the weight below extrusion wig!!!!!

  The most correct carding method is: from the bottom up bit by bit comb! Washing method:

  1. Will wash hair element to join in the cold water wig for eight minutes, gently and decontamination don't force twist crowded and then rinse with water gently. The washing, be sure to remember don't want disorderly knead ~ ~ should follow the one direction slowly by hand to twist crowded hair, gentle some action is m problem drop ~ = V = ~ hair kids also is very tender's ~ ~ ~

  2. Use dry towel blot moisture encase wig, rack to dry, not exposure or use hair dryer

All rights reserved @ 2012 XuChangTian tai industrial CO., LTD TEL:+86-374-8097998 FAX:+86-374-8097968
Copyright © 2012 www.tt-hair.com All Rights Reserved 豫ICP备13000929号  Powered by www.300.cn